If you need to widen a doorway for wheelchair access, the good news is that the fix is often smaller than you expect. A standard interior door leaves roughly 28 to 30 inches of clear opening, which is too tight for most wheelchairs and many walkers. The right solution depends on how much width you need and what is inside the wall. This guide covers the options, typical costs, and the questions to ask before work begins.
Widen a Doorway for Wheelchair: Costs, Options, and Ontario Tips
If you need to widen a doorway for wheelchair access, the good news is that the fix is often smaller than you expect. A standard interior door leaves roughly 28 to 30 inches of clear opening, which is too tight for most wheelchairs and many walkers. The right solution depends on how much width you need and what is inside the wall. This guide covers the options, typical costs, and the questions to ask before work begins.
How Wide Should a Wheelchair Accessible Doorway Be?
The Ontario Building Code requires a clear opening of at least 850 mm (about 33.5 inches) for doorways on a barrier-free path of travel, according to Trillium Group’s overview of barrier-free door requirements. That rule applies to public and commercial buildings. In a private home it is still a useful target.
Clear opening is not the same as door size. It is measured from the face of the open door to the opposite stop, so a 36-inch door typically gives only about 33.5 inches of clear width. Hinges, door thickness, and trim all eat into the number.
Three Ways to Widen a Doorway for Wheelchair Access
1. Offset Hinges (Smallest Fix)
Swing-clear or offset hinges let the door swing fully out of the opening. They add roughly 1.5 to 2 inches of clear width with no reframing. Installation takes about 20 minutes, and the hardware is inexpensive. This is often enough when the opening is only an inch or two short.
2. Replace the Door or Use a Pocket Door
A wider door, or a pocket door that slides into the wall, removes the swing entirely. Pocket doors also help in small bathrooms where a swinging door would block the turning space. They do require an opening in the wall cavity, so check for wiring and plumbing first.
3. Reframe and Enlarge the Opening
When the opening is much too narrow, the wall itself has to change. The framing is cut back, a new header is installed, and the drywall, trim, and flooring are repaired. This is the most involved option, and the cost depends on the wall type.
Doorway Widening Cost: What to Expect
Costs vary with the wall, the finishes, and what is hidden inside. These ranges come from Block Renovation’s doorway widening guide, which reports them in dollars without naming a currency:
| Project | Typical range |
|---|---|
| Offset hinges | $40–$90 per pair |
| Pocket door hardware | $200–$600 |
| Non-load-bearing wall | $600–$2,000 |
| Load-bearing wall, single storey | $2,500–$10,000 |
| Structural engineer | $300–$1,000 |
| Permit | $50–$500 |
Budget a 10 to 20 percent contingency. Costs climb quickly if the opening reveals old wiring, plumbing, or materials that need special handling.
Load-Bearing or Not? Why It Matters
A non-load-bearing wall is a simple framing job. A load-bearing wall carries weight from above, so it needs a properly sized header and temporary supports while the work is done. An engineer should size that beam, and in most municipalities the change needs a permit.
Skipping the permit can cause trouble later. A buyer’s inspector may flag unpermitted structural work when you sell.
Check the Rest of the Route
A wider door only helps if the path leading to it works. Look at these before you commit:
- Hallway width. A wheelchair needs space to turn into the opening.
- Thresholds. Keep them as low as possible, with bevelled edges.
- Door hardware. Lever handles are easier than knobs.
- Floor transitions. Remove or smooth any ridge between rooms.
- Turning space. Bathrooms and bedrooms often need a 60-inch turning circle.
Funding may reduce the cost. Doorway widening done as part of an accessibility project may qualify for the federal Home Accessibility Tax Credit, which covers 15% of up to $20,000 in eligible costs. Confirm eligibility with the CRA before you start.
Choosing a Contractor for Doorway Widening
Doorway work looks simple until the wall is open. An accessibility-focused contractor will check what is inside the wall before quoting, measure for the equipment the person actually uses, and plan the route from room to room rather than one doorway at a time.
At In-Trend Home Solutions, we assess the whole path as part of every accessible home renovation. See our bathroom renovation services for doorway and turning-space work in bathrooms, or learn about our accessible ramps for the entrance.
The Bottom Line
To make a doorway wider for wheelchair use, start small: measure the clear opening, try offset hinges, and move to a pocket door or reframing only if you need more. Get a quote that covers permits and the wall type before work begins. Ready for an assessment? Contact In-Trend to book a consultation.